Incredible 2009 Polaris Ranger Check Engine Light Ideas. Web i have a 2009 polaris ranger 700 efi. The light will blink a code with two numbers, something like two blinks, a small pause, then 6 blinks, which would be 26.
2009 Polaris RANGER UTV / SxS Line Up New UTV Models from www.atvriders.com
Web #1 · feb 27, 2009 hi every one. Web to check the codes start with the ranger turned off, turn the key on and off two times, then turn the key on and leave it on. Thats just means its running through its list of sensors.
I Did Find A Broken Wire And Fixed It.
Web resetting the check engine light on a polaris ranger 900 is a breeze. I found the code it was 45. Happened on saturday afternoon but they went off by they're own late.
Web #2 · Aug 8, 2009 Brian, Has It Provided You With Any Codes To Start With ?
We only need to worry about the check engine light when it comes on when the motor is running. Wait shows up then nothing. This should work till u get the new sensor.
I Checked Oil And It Is Correct And There Doesn't Appear To Be Anything Wrong.
It will blink 2 codes (example: I found out this is a problem that polaris has. Disconnected battery for 20 seconds to clear check engine still on.
I Am Mechanical But No Experience With Utv's And The Like.
The dealership wants an obscene amount of money to transport it. After riding it for around thirty minutes, when i stop it continues to idle high. Did diagnostic check for blink codes displayed 22 25 41 46.
Web 2009 Polaris Ranger Check Engine Light.
For 2014 or newer models, just hold the “mode/set” button for three to five seconds. Which said it was the barometric pressure sensor. Everything seems to be operating correctly for the most part other than i’m not getting a gear indication on my display or and my four wheel drive doesn’t seem to be working.
No comments:
Post a Comment